HYPERION USB ADAPTER FOR PROGRAMMING TITAN ESC & PC TO EOS06XX

#HP-TI-PRGUSB:
Hyperion TITAN  USB/SERIAL 4-Pin Adapter Cable

Applications:
1) All TITAN MOTOR CONTROLLERS (ESC)
2) Emeter v1 and Emeter v2*
3) EOS 06xxi CHARGERS to PC Port for:
     *EOS0610i NET and DUO - Firmware upgrades and PC Software
     *EOS0606i DC and AC/DC - PC Software (to be confirmed)

USING the TI-PRGUSB ADAPTER :
TITAN ESC
* Whenever connecting the PRGUSB Adapter, be sure that GRD/V+/Tx/Rx orientation is correct.
* For TITAN ESC, note that the "blanked" pin on the adapter connector is always next to GRD
*The Adapter supplies power to the TITAN ESC, so a battery pack must NOT be connected to the TITAN ESC during programming.

EMETER v1
*HP-TI-PRGUSB cannot be connected directly to EMETER. You must first insert the adapter for Emeter, which is included with every USB TI-PRGUSB. (pictured above, at bottom right of photo)
*For EMETER v1, note that you MUST turn Emeter ON first, then connect TI-PRGUSB to Emeter, when using Emeter PC Data Software.
(otherwise, you will see a "low battery" warning from Emeter...)